ADSS CABLE OTHER REQUIREMENTS

ADSS Cable Clamp is one of our products. Let me introduce other requirements of ADSS optical cable.

　　The longitudinal twist of ADSS optical cable will cause damage, so non-polar insulated braided traction rope and anti-twist device must be used during construction.

　　The glass fiber core in the ADSS optical cable will be broken after being damp and water, so during construction, whether it is an opening test or after the construction, the end of the optical cable must be sealed with a waterproof tape.

　　The model, length, number of cores, spans and matching hardware configuration of each reel of optical cable are different, and are produced according to the design of the design institute. Each cable has a uniform number, and each number corresponds to a certain base tower in a certain line. Therefore, the cables shall not be arbitrarily adjusted during construction. Optical cable fittings are designed and produced according to the diameter, tension and span of each optical cable, and cannot be replaced at will. The construction team must strictly follow the cable tray and hardware configuration table designed by the design institute to carry out the construction of optical cable exhibition.

　　On the pole tower at the splice box of each reel of optical cables, there must be enough excess cables left, and the length of the excess cables of the connectors is ≥ the height of the optical cable hanging point from the ground + 25 meters. After the optical cable enters the equipment room, there must be enough excess cable. After the optical cable enters the equipment room and reaches the installation position, the length of the excess cable is ≥25 meters.

　　Under the premise of ensuring a safe distance, the installation height of the optical cable splice box and the remaining cable reel is ≥10M from the ground. When conditions permit, the installation position should be raised as much as possible.

　Aluminum Tension Clamp is also one of our products, welcome to visit our website!